Outline each section separately with the color formula. Refer to your records for the previously used formula and timing, and be sure to do a patch test 48 hours before retouching.Īpply to dry hair, using applicator bottle or brush. When application to shaft and ends is complete, immediately mix a fresh formula using 10- or 20-volume developer and apply to root area.įor longer hair, use cotton strips to protect the root area while color is applied to shaft and ends. If you are an experienced colorist, you may wish to use 30-or 40-volume developer in the formula for use on the shaft and ends. Leave color on hair until color is uniform from roots to ends.Īt shampoo bowl, spray hair with a little warm water and work into lather and rinse thoroughly. (Normal processing time is approximately 30 minutes, but for maximum lightening and gray coverage allow complete development time of 45 minutes). Mix a fresh hair color formula and apply to root area, making certain that hair shafts and ends are thoroughly re-saturated.Īfter 15 minutes, check a strand for color development. Check strand for color development.Ĭontinue checking until hair is decolorized half as much as desired. Application is made 1 inch away from scalp because the hair away from the root area receives less natural body heat and will take a little longer to decolorize.Īllow color to develop for a minimum of 15 minutes. Use this method when the color is one or more Levels lighter than your client's natural hair color Level.Īpply to dry hair, beginning one inch away from scalp, down to and including the ends. Shampoo and rinse until water runs clear. When desired color is achieved, spray hair with a little warm water and work into lather at the shampoo bowl. (Normal processing time is approximately 30 minutes, but for maximum lightening and gray coverage allow complete development time of 45 minutes.) Strand test the ends to determine color development and timing.Īllow color to develop for a minimum of 15 minutes.ĭo a strand test for color development. Allow mixture to develop for about 15 minutes, then work through to the ends. Note: If ends are porous or damaged, apply the mixture only to three-quarters of the strand first. Apply generously with applicator bottle or brush, making sure hair is thoroughly saturated. Take ¼ to ½ inch partings and begin application at root area, working color all the way down to the ends immediately. Use this method when color is close to or deeper than the natural Level of hair color.Īpply to dry hair. Always do a preliminary patch test 48 hours before applying color.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |